In this article, I’m gonna introduce the Vinci X 2 Kit by VOOPOO. If you are looking for a powerful pod mod device powered by the 18650 battery, this is surely what you want. Here are more details.
The Vinci X 2 utilizes a difficult to manufacture single plating/grain process to permit the refraction of light. This results in an appearance that reflects different coatings and textures for a dazzling effect. On the control face, you will see a huge display screen with full-color font and the ability to change the theme colors. But, that’s not all. There are actually two different UIs to choose from. Near the top of the mod, there’s a physical slider that can be maneuvered left or right to fully open or close the air intake. This means you can really experience your favorite puff setting in combination with whatever coil you choose.
Powering the kit is a 18650 battery, while it is onboard you may recharge it via a Type-C USB port that has a 2A current. Built with the newest Gene AI 2.0 chipset, the device can operate with up to 80W of power. You may adjust wattage from 5W and operate in several different modes such as the power, smart, and RBA settings. In smart mode, the coil inside the pod is instantly recognized for the best possible vapor production, while the RBA mode has no limitations whatsoever, so it is only recommended for veteran vapers. For safety reasons, the chipboard also has integrated safeguards such as overtime, short circuit, overcharge, over-current, over-discharge, reverse polarity, and maximum power protection.
The Vinci X 2 cartridge can store a massive 6.5mL of vape juice, refilled via a side-fill plug to make the process effortless. The mouthpiece at the top is flat, making it comfortable in the mouth while enhancing airflow via airflow holes that produce smoother airflow and better vapor production. The X 2 also uses Navi coils of which there are 9 different versions. With purchase, you will get both a 0.3ohm Pnp-VM1 and a 0.15 PnP-VM6 Coil. The VM1 has a single mesh heating element with a 32 to 40W range, while the VM6 should be used from 60 to 80W. Best of all, these coils use a simple push/pull installation process to make the process fast and mess-free. The coils are also quite affordable.